Overgrown Fence Lines and Back Lots Cleared Out

Brush removal in Decatur for rural and residential properties with overgrown tree lines, fence rows, or back-lot growth that equipment cannot easily reach

Decades of unchecked fence-line growth and volunteer brush are a common feature on older farmsteads around Decatur—tree lines that started as windbreaks and expanded outward, fence rows that accumulated decades of multiflora rose and saplings, and back lots where nobody has run equipment in years. Gold Star Services LLC clears this kind of overgrowth using a mini excavator, cutting and pushing material that would be impractical to clear with a tractor and brush hog. The company is owner-operated, licensed and insured, and the owner brings roughly 25 years of equipment experience to properties across Adams County.


The process involves cutting or pushing brush with the mini excavator, then piling it on site or hauling it away depending on what the customer needs. Where the ground will be put back into use—whether for row crop, pasture, or a lawn extension—stumps and roots are dug out so the surface can be graded and the ground used without obstruction. Before the job is priced, it is worth clarifying whether debris hauling is included or whether the work scope ends at piling material on site, since that distinction significantly affects both the scope and the logistics of the job.


Call Gold Star Services at (765) 760-1645 to discuss your property and get a free estimate on what clearing the overgrowth will involve.

The Difference Between Cutting Back and Clearing Out

Cutting brush to ground level with a mower or brush hog is different from removal. Cut material regrows from established root systems—particularly species like multiflora rose, autumn olive, and box elder that are common along Adams County fence lines—often returning to the same height within two to three growing seasons. Pushing and digging with an excavator removes the root mass in most cases, which interrupts the regrowth cycle at the source rather than managing it at the surface annually.


After clearing, what was a tangled fence line or brushy back corner becomes workable ground or open pasture edge. Fence posts buried in the growth become visible and accessible for repair or replacement. In areas where stumps and roots are dug out, the surface can be graded flat and either seeded or put into agricultural use without equipment striking buried wood. The change in usable acreage on a property that has let fence rows go for twenty or thirty years can be substantial once the material is out.


Access is a real consideration on older farmsteads where brush has closed off a lane or grown tight against an existing fence line. The mini excavator can work in tighter conditions than a larger machine, which matters when the brush to be cleared is adjacent to a standing fence, a building, or an overhead utility line that limits where heavier equipment can swing.

Common Questions About the Clearing Work

Brush removal looks straightforward from a distance, but the sequence of decisions made during the job—what gets dug out versus cut, where debris goes, how the ground is left—shapes both the immediate result and how that ground performs afterward. The questions below address those specifics.

  • What determines whether stumps get removed or left in place?

    The intended use of the ground after clearing drives that decision. If the area will be farmed, mowed, or graded, stumps and subsurface roots need to come out so equipment can work the surface cleanly. If the area is being cleared only to open it up visually or create access without farming it, leaving stumps cut low may be acceptable and reduces the scope of work.

  • How does the mini excavator handle thick growth near an existing fence line?

    The excavator's reach and bucket allow material to be pulled and pushed away from the fence rather than into it, which protects the existing structure. On fence lines with active wire, the crew works from the brush side to avoid catching wire in the bucket, and posts that are buried in root masses get exposed before the root ball is removed.

  • What is the difference between piling debris on site and hauling it away?

    Piling leaves the cleared material on the property in a location the customer designates—often a field corner or a low area being filled. Hauling removes it entirely, which is the right choice when there is no good pile location or when the volume of material is too large to manage on site. These are separate scope items that affect what the job involves.

  • How does the age of the fence-line growth in Decatur's older farmsteads affect the clearing approach?

    Growth that has been established for decades develops significant root masses and interlocked canopy, which means material does not simply cut and fall—it has to be worked loose and staged for removal. Older multiflora rose thickets in particular develop root crowns that are several inches across and require excavator work to extract fully rather than cut at the surface.

  • What does the ground look like after the stumps and roots are removed?

    Removing root masses leaves irregular depressions where the root ball was. Those depressions are typically filled during a follow-on grading pass, which brings the surface to a consistent finished elevation that can be seeded or farmed. On properties where grading is part of the scope, this step happens before the job is considered complete.

Gold Star Services LLC also clears brush in Berne, Bluffton, Portland, Fort Wayne, and Van Wert. To review your fence line or back-lot overgrowth and confirm what the clearing work will involve, call Gold Star Services at (765) 760-1645 for a free on-site estimate.